24hourcampfire.com
24hourcampfire.com
Previous Thread
Next Thread
Print Thread
Hop To
#10394374 09/06/15
Joined: Apr 2013
Posts: 6,971
S
Campfire Tracker
OP Online Content
Campfire Tracker
S
Joined: Apr 2013
Posts: 6,971
Just purchased my first "Big Bore", unless you consider the .375 H&H to be in this category.

Any information about the 416 Taylor would be greatly appreciated.
What should I expect as far as recoil from a 9lb rifle?

BP-B2

Joined: Oct 2004
Posts: 2,050
H
Campfire Regular
Online Content
Campfire Regular
H
Joined: Oct 2004
Posts: 2,050
What did you get and where, if I may ask,,, I'm a SAKO fan too and have contemplating building a 416 Taylor on a SAKO action.


And these zombies line up and eat from the media’s trough

Cowards CANNOT be free. Nor should they be.


~Molɔ̀ːn Labé Skýla~
Joined: Aug 2014
Posts: 4,189
F
Campfire Tracker
Offline
Campfire Tracker
F
Joined: Aug 2014
Posts: 4,189

Joined: Sep 2009
Posts: 46,211
G
Campfire 'Bwana
Offline
Campfire 'Bwana
G
Joined: Sep 2009
Posts: 46,211
Hey Sako, check the 416 Taylor thread below, a lot of useful info there too, the 416 Taylor is a very well mannered kicker, a lot of bang for the buck so to speak for the amount of performance you're sending downrange.

My VZ-24 Mauser weighs about 9.5 lbs all up and is a pleasure to shoot.

Good Luck with this fun and VERY efficient round.

Gunner


Trump Won!
Joined: Apr 2010
Posts: 207
I
Campfire Member
Offline
Campfire Member
I
Joined: Apr 2010
Posts: 207
These 416 bullets have a split personality. There is a Rigby nose profile, and a Remington nose profile. The Rigby bullet sticks out farther from the case mouth. The Remington goes deeper into the case. Both of these being crimped into their respective cannelures. The Speer 350 gr. Mag Tip has a Remington nose profile. Obviously, putting a Rigby nosed bullet in will give you some added capacity.

If I seat a Rigby bullet all the way out to the 3.51" limit in my M-98's extended magazine, I can equal the 416 Ruger's net capacity in a standard magazine. My 416 is a wildcat, made from 375 Ruger Brass, and is the same length as their 2.6 inch long 375's. All my case taper's lost capacity, evaporates when I move a 416 bullet forwards from 3.34 to 3.51 inches, C.O.A.L. The 416 Taylor will mirror this, but with just a bit more, as its a couple of grains less capacity, than my wildcat.

If you are merely gleaning data from printed pages, this dichotomy in the 416 bullets, needs to be addressed. Rigby bullets in a Taylor with a slightly extended magazine, kicks things up a notch or two. Also, the maximum designed penetration for those Speer 350 gr. Mag. Tips comes with only 2400 fps.

FWIW, my 416 uses a L. Walther 1 in 14 twist barrel. In the early Taylors, there were some 1 in 10 twist bbl's, which could be deathly accurate, with 400 gr. bullets at lower speeds than either the Rigbys or the Remingtons.

Woodleigh e-mailed me that my magazine length, plus my 1 in 14 bbl. will handle their 450 gr. S.P. or Solid bullet with the Rigby profile. I picked up a N.O.S. bag of 410 solids, and these kick the pressures up so that I'm only able to do abut 2150-2200 fps., before I start getting cases setting back. I built my wildcat rifle to duplicate as closely as possible, Harry Selby's infamous military Mauser, 416 Rigby.

With my shorter 2.6 inch long wildcatted 375 Ruger cases, I didn't weaken my receiver's bottom bolt lug abutment. In my R.Famage Colombian military 30-06 action, my cartridges drop cleanly in between the clip slot and the factory notch in the front receiver ring. My G.S. wouldn't notch the side of my receiver, in the right rail recess, like Selby's, as he thought this might weaken it. My rifle's weight and balance are right on point with Mr. Selby's, as taken from an article by Layne Simpson, who handled and shot it, some years ago, at Wingmead Plantation, in LA.

IC B2


Moderated by  RickBin 

Link Copied to Clipboard
YB23

Who's Online Now
622 members (09wingates, 2003and2013, 007FJ, 160user, 10gaugeman, 17CalFan, 56 invisible), 2,521 guests, and 1,157 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums81
Topics1,187,599
Posts18,398,261
Members73,817
Most Online11,491
Jul 7th, 2023


 







Fish & Game Departments | Solunar Tables | Mission Statement | Privacy Policy | Contact Us | DMCA
Hunting | Fishing | Camping | Backpacking | Reloading | Campfire Forums | Gear Shop
Copyright © 2000-2024 24hourcampfire.com, Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5
(Release build 20201027)
Responsive Width:

PHP: 7.3.33 Page Time: 0.222s Queries: 14 (0.004s) Memory: 0.8087 MB (Peak: 0.8525 MB) Data Comp: Zlib Server Time: 2024-03-28 13:12:20 UTC
Valid HTML 5 and Valid CSS