|
|
|
|
Joined: Nov 2015
Posts: 4
New Member
|
OP
New Member
Joined: Nov 2015
Posts: 4 |
Hi All,
I just purchased a model 99, ser # C0070xx, from reading forums on this site I think it is mid 70s. It has a ugly finish on the wood and I want to refinish it. I tried to remove the forearm but is extremely tight. Any suggestions ? I can move the tip of the forearm about 1/8 " down from the barrel with lots of force! Just dont want to break it!
|
|
|
|
|
Joined: Sep 2005
Posts: 17,687
Campfire Ranger
|
|
Campfire Ranger
Joined: Sep 2005
Posts: 17,687 |
Should just come off, when you take the screw out, Id go slow and apply presure. Now if its a older Take down always have the lever open, before you take the forarm off.
Deer Camp! about as good as it gets!
|
|
|
|
|
Joined: Nov 2015
Posts: 4
New Member
|
|
OP
New Member
Joined: Nov 2015
Posts: 4 |
Got it thanks. Used more force.
|
|
|
|
|
Joined: Apr 2013
Posts: 14,038
Campfire Outfitter
|
|
Campfire Outfitter
Joined: Apr 2013
Posts: 14,038 |
never use force! just get a bigger hammer.
seriously though with the 99 if it is not a takedown model remove the forarm stud screw and tap the sides while putting downward pressure on the tip.
with a takedown model always have the action open. if your model is an f the forearm stud is soldered on. DON'T over tighten the screw. the stud can pop off. don't ask how I know. heartbreak
the consolidation of the states into one vast republic, sure to be aggressive abroad and despotic at home, will be the certain precursor of that ruin which has overwhelmed all those that have preceded. Robert E Lee
~Molɔ̀ːn Labé Skýla~
|
|
|
|
|
614 members (1234, 12344mag, 10Glocks, 17CalFan, 10gaugemag, 007FJ, 73 invisible),
2,579
guests, and
1,268
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
Forums81
Topics1,190,667
Posts18,455,870
Members73,909
| |
Most Online11,491
Jul 7th, 2023
|
|
|
|
|
|
