Home Forums Hunting & Shooting Savage Collectors Spare Parts Needed Thread

Not really up on the Marlin sight but aren't the ones you listed more like what is on the Savage 1895 with the screw in the face. There is also a Ballard sight that was used that has little points out the side at the bottom rear. I think I've seen them on Marlins and a couple of Savage 1895's.

Looks too short to me. Poor condition too. Your gun deserves better.

I'll continue to look!

Just as a hint.. easier to find yourself a Lyman 1A and just replace that rear sight with a blank. Peep sights are awesome anyway.

Like this 32-40.

Rick, A lot of them didn't have a screw in them.

Thanks, Loggah. Now I can start buying Marlins and steal the sights.

One marlin 1893 i bought had the correct rear sight for a savage 99T on it, its still on it,im saving it in case i pick up a "T" that needs one !!

Someone stripped the sight and replaced it with one of those old cheap Savage sights.

gun show today ,tomorrow 1 guy has lots of Savage rear sights

norm

Norm, if you've a mind to....

sorry Jorge guy took off Sat night , family stuff i herd . i have his number , you want me to call him and find out what he wants for one??

norm

Please, sir

OK give me a few days

norm

Impossible to find scope mounts...I give up.

Does anyone have, or know where, I can find a set of mounts/rings to fit these holes?

That is how the old Weaver U and Q model rings mounted. The U series is for 1" scopes and the Q is for 3/4".

I have a set of the 1" for the 99. Do you know what threads are tapped into the receiver? Probably #6-40 but could be #6-48.

Really, so they exist...wow, I was beginning to doubt it. The threads are the same as the factory drilled tang sight; it's a 1940 99G.

Are you willing to part with them?

Thanks again for the help.

Chip

Well, the threads are #8-40 then. You see all kinds. It was whatever the driller had a mind to do I guess.

Yes, I'd part with a set. Let's move this to the private message exchange. Look for a flashing red envelope near the top center of the screen.

Hello,

I'm a newbie here. Was referred by a friend. I shoot a 99A in 250-3000 and recently bought one in .243 Winchester which arrived (drum roll) with a cracked butt stock.
I know Boyd's and others make repros. I'm looking to source an original carbine/straight grip stock if anyone knows a source.
I know it's like pulling teeth, just turning over rocks and hoping to come across the little old lady with a whole closet full of them.

Michael

Hello, I am new to this, but I need the trigger guard, magazine box, spring and follower for a Savage 1920 bolt action rifle. I have a nice rifle but none of the lower "guts". Can anyone help me?

Looking for a front sight blade for a 99G