I just learned about this forum and I'm excited to join. I tried to find a new member introduction forum but had no luck, I hate to make my initial post a sales ad. But here I go.
I can supply references from multiple forums for successful painless online transactions. I use the same username on all forums so I'm easy to check into
Here is the story, I picked this up to strip it down and use the action for a ultralight weight hunting rifle build. But since I've decided to build a 6.5 Creedmoor, so I need a short action. Alos, this thing shoots quite well and I just feel bad tearing it apart.
As you can see someone at some point gave it a half-assed coating job. It's a home job of duracoat as far as I can tell, and it does clean off with acetone. I spent a few minutes stripping it off the bolt, but then left it alone since it would get media blasted anyways since I was going to do a build. I'm going to leave it as is and let the new owner do what they like, but the coating has poor adhesion and does flake off without much effort.
I am going to sell this to raise the cash to purchase a titanium action from Pierce Eng. Then I can build what I was planning on without destroying this nice rifle.
$1575 shipped to your FFL.
[img]
http://i1341.photobucket.com/albums/o758/mtar15/27FC1D2F-8F2B-4183-969B-3E6DED81D567_zpsbv2xviaz.jpg[/img]
[img]
http://i1341.photobucket.com/albums/o758/mtar15/CDF383A6-8EC7-4DA7-BC35-4F2E7EF11971_zpslimowlwv.jpg[/img]