Home Forums Reloading Bullet Casting flat nose 22 mold wanted

Print Thread

Hop To

flat nose 22 mold wanted #9230012 10/04/14
Joined: Mar 2002 Posts: 2,572 PA B birddog65 OP Campfire Regular
OP birddog65 Campfire Regular B Joined: Mar 2002 Posts: 2,572 PA	looking for 224 mold to load for a 22 Hornet. 35-45 grains thanks. If you really like something,you better buy two!

GB1

Re: flat nose 22 mold wanted birddog65 #9234276 10/06/14
Joined: Nov 2005 Posts: 23,071 Annapolis, Md. G gnoahhh Campfire Ranger
gnoahhh Campfire Ranger G Joined: Nov 2005 Posts: 23,071 Annapolis, Md.	Sounds like you are looking for a Lyman 225107 mould. What's the rate of twist in your barrel? Throat diameter? Velocity level you wish to achieve? "You can lead a man to logic, but you cannot make him think." Joe Harz "Always certain, often right." Keith McCafferty

Re: flat nose 22 mold wanted gnoahhh #9242756 10/09/14
Joined: Mar 2010 Posts: 126 NC Reloader762 Campfire Member
Reloader762 Campfire Member Joined: Mar 2010 Posts: 126 NC	This one might fit the bill. There are couple others in stock as well that may interest you in both Plain base or gas check version. http://noebulletmolds.com/NV/produc...31&osCsid=mhee62i9tod9r6ipovk9eo9rn7 Artisan in Lead, bullets and powder

Moderated by RickBin

Link Copied to Clipboard

AX24

168 members (12344mag, 338rcm, 1eyedmule, 257 mag, 2UP, 300jimmy, 14 invisible), 1,364 guests, and 872 robots.

Key: Admin, Global Mod, Mod

April
S	M	T	W	T	F	S
	1	2	3	4	5	6
7	8	9	10	11	12	13
14	15	16	17	18	19	20
21	22	23	24	25	26	27
28	29	30

Forum Statistics

Forums81

Topics1,191,061

Posts18,463,278

Members73,923

Most Online11,491
Jul 7th, 2023

Responsive Width:

PHP: 7.3.33 Page Time: 0.074s Queries: 14 (0.002s) Memory: 0.7936 MB (Peak: 0.8252 MB) Data Comp: Zlib Server Time: 2024-04-23 10:18:52 UTC
Valid HTML 5 and Valid CSS