When it rains...it pours,bitches.
Been (2) days of R&D trying to defeat the zero-stop and cain't. Tried numerous notions,as per what logistics allowed and finally was able to connect dots via mainstay OEM offerings. One can ring the bell,for less than fifty fhuqking cents.
I knew sooner or later,I'd be able to procure the remedy.
It's this fhuqking simplistic and note that it literally takes (2) to tango.
Install thusly,on previously zero'd erector and simply pre-load the amount of STOP,as per whim. I like to allow enough,to thread needles at 25yds,less holdoff,but it can be did in any fashion that suits.
Was hoping to really load up Turntitude resistance(especially for windage) and sought to incorporate a beefed exterior o-ring on the erector spindle's shroud. Couldn't score the larger size I wanted,so had to punt.
Stacking a second OEM sized 'ring in the faux race beneath the issued,was too much of a good thing and wouldn't bear fruit. The notions stands and I'll source the requisite offerings,once I touch pavement.
Haven't gone CRAZY,but have shot the 'stop in a couple dozen Fixed Fhuqker offerings and there is no concession.
Shot hard today,from spittin' distances to a mile ++.
You've been led to water and that pun,is likely intended.
Hint...............
(P.S. and by the way)
You can flog on 'em hard enough to bend the erector spindle and they don't give a fhuqk...yet retaining zero,tracking and the gumption to refrain fogging.
Just saying.
[img]http://imagizer.imageshack.us/v2/1280x1024q90/538/62DB8C.jpg[/img]