Home Forums Lever Action Central Lever Actions - General Winchester M94 AE scope base

Does anyone make a one piece Weaver type scope base for a Winchester M94 AE. I am thinking about mounting a small red dot or a reflex type site and I don't think the two piece mounts would work. Any input or suggestions would be appreciated.

Personally, for a red dot/reflex sight on a 94, I'd go this route:

http://www.midwestgunworks.com/page/mgwi/prod/winchester-model-94-accessories/2196A

I have a Browning 71 with the red dot on the back of the receiver in the peep sight location, it's too close to my eyes for what I want it to do. I'd rather have it further forward.

Here's a rear mount for the Burris Fastfire sight:

Burris Winchester 94 FastFire Red Dot Sight Plate Mount Matte

http://www.natchezss.com/product.cfm?contentID=productDetail&prodID=BU410334

Looks like it fits the pre-drilled mounting holes on the top of the 94 receiver.

It would good to your thoughts on it when you are done, I'm thinking of something like this for a newer 94 in 38-55 for deer this Fall.

I have a Marlin 1895GSLTD that I sent off to Wild West Guns for their Alaska Guide Gun build. (457 Wild West Mag & all!!)They have a great scout scope set up. I was not sure about the scout set up BUT after using it I love it! I am trading for a Winchester M94 AE Trapper and was just thinking about my next move. Reflex or RedDot. The only mounts I have seen (just looking for 24hrs) are the two piece. Thanks for the options!!!