I have one that is about ten years old it is a gold hunter 3 and a half I am going to purchase some chokes off of a member on here but dont know if they will fit. Will the standard browning invector chokes fit it? I had BPS and I know that is what it used

I know this is probably a dumb question but do you have any factory chokes for the gun now? If so, I would expect that the choke will say invector or invector plus on it. Mine do. If you end up needing any more chokes in invector plus let me know. I have some that are left over from a Browning I sold.
Bob

My Gold Hunter uses Invector + tubes.

hangunnr

Ditto hangunnr, my Gold Hunter uses Invector+ choke tubes. I use a patternmaster choke in my gold hunter for turkey hunting in xx full and it shoots great.

mine uses invector plus

All the 12 gauge guns used Invector PLUS guns, but some of the older 20ga guns used Standard Invector tubes.

Other note: 3" and 3.5" barrels/receivers do not interchange.

My 3.5 Gold uses Invector+ also. The length of an I+ is 2-3 times longer than the standard Invector choke.

The barrel may also have a stamping on it.

It will be stamped on the barrel:



The visual difference: