Another batch, ready to roll. If you already have some, you can send them in to be milled for $30/TYD.

New sets $60/TYD

Full Story, Talley Modification

Are these available in 30mm?

I don't have any at the moment, but they can be done.

I got a pair of these a month ago and put them on a Superlite, I couldn't be more happy.
Good people to work with and they will get you exactly what you want. A++++

+1

16 Bore,
To clarify, these were "lows" to start and now might be "extra lows"? Are you trimming off about .100" or was it .120"
Thanks for clarifying.

That's correct, started life as lows and went 0.100 lower.

Up for the late shift...

Burnt toast and coffee bump

Upsy daisy.

Dove season's a coming bump...

Let me know when you get some 30's

I'll take a set of 1" low matte if you have a pair. Pm sent

I recently got a 7mm Rem Superlite that I haven't had time to fool with, but I think I need a set of 1" matte modified Lows.

Can you send them with the screws already shortened? Or should I check it first?

It seems to me like they'd all either need shortened,or not.

Thanks,
Jeff

The only one that needs to be shortened is the rear on the front base where the chase is for the bolt face. The holes are deep enough for the rest.

You planning on any 30mm Lows?

As soon as I can get my hands on some, been looking since June to no avail.....

PM sent

This batch is gone, stay tuned for another.....

Miscounted, have one set left. Few more in about another week or so. This batch will have a couple 30mm lows, one is spoken for.

Let me know on a 30 thanks Jerrad

Will do.

Looks like both are spoken for...

I have a set of mediums (30mm) on my Tikka. Can you mill those?
I had to go medium to clear the power adjust ring on the Vortex. Sits too high above the barrel (over 1/4 inch)

No problem..

I've got a coupla sets of 1" lows ready to roll.....

Sold...

Tag

PM Sent for a set of 30's. Thx.

Is that a 6x42 in the pic above? Nice work btw.