I've been going through all my AR stuff and thinning out what I don't use or need.

Everything bellow is new accept the barrel, the barrel was fired for maybe 30 rounds or so on a different upper. Then later installed on this new upper.

All the Cerakote was done perfessionaly by a local place. BigHorn Custom Firearms and Finishes.

#1

Top assembly in photo

New... Anderson Arms upper receiver with brass deflector/ no forward assist and 10" Keymod handguard with barrel nut and all appropriate hardware. Cerakoted in heat cure Barrett Brown. This was going to be for a 300 Blackout pistol build. Comes with 3 Keymod 8 slot rail sections. $ 160.00 Shipped.


#2

I can't recal if the upper on this assembly is a new Anderson or Bear Creek? Either way it is a new Mil-Spec upper with M4 cuts, 15" Keymod handguard, comes with 3 keymod 8 slot rail sections. All Cerakoted in heat cure Barrett Brown. The barrel is a 16" light contour, custom contoured by Tactical Ammunition, moly barrel chambered in .223 Wylde with a 1-7 twist and a mid length gas system. This barrel maybe has 30 rounds on it while it was on another upper. All parts on this upper are new with the acception of the barrel. 1/2-28 thread A2 style hider. NO bolt carrier group or charging handle $260.00 Shipped.


Payment by PayPal plus fee or as friends/ family. I leave that to the discrection of the purchaser.

$390.00 Shipped for both if purchased together shipped to one address.







The center barrel in the photo bellow is the barrel used on the upper above.



I've had 15 or so of these barrels done for me in the 7 twist .223 Wylde chambering with the 1-7 twist but in 4 different configurations. 5 or so of the barrels were sold here on the forum. Bellow is about the average off the bench at 100 yards.

I take # 2 send me the payment details.

#2 Sold pending funds.

#1 Reduced $140.00 Shipped.