I took a Savage Model 11 Lightweight Hunter barreled action to Raleigh (90 miles) to have it Cerakoted. Had it shipped back to me. I cannot get the trigger to work. When I push the trigger guard button to install the bolt it stays pushed in. Trigger will not even move. I am trigger illiterate.

That looks like the new bottom bolt release system. Study your owner's manual. It was tricky the first time I took the rifle apart to clean it and had to put back together.

I suspect some dimensions have changed.

The lever in the upper left side of the second picture is the problem. I should have stated that in my first post. It tends to snag while going back into the stock.

I finally figured it out. I needed a lot more tension on the spring under the tang.