Anyone tried to do this finish? I'm thinking about it for the kids tube, but I'm not sure exactly where to start. I'm thinking a small da with 180 but the lathe speed is purely a guess.
Any success or failure input greatly appreciated.
Thanks.
No worries folks, I Googled
swizzledick... Thank me later.
LMAO!!!!
That guy in the blue golf shirt kinda looks like K-woodie...
LMAO!!!!
That guy in the blue golf shirt kinda looks like K-woodie...
Wrong! I never wear short britches!!
LMAO!!!!
That guy in the blue golf shirt kinda looks like K-woodie...
Wrong! I never wear short britches!!
Not without knee high socks...
Perusing the custom rifle blueprints thread came across this with reference of orbital sander and low speed lathe. Maybe that's a swizzledick?
That's the finish I'm after, but I've been trying to dupe it with my da, mini da, mini disc....so far, no bueno.
roll it on a table using a jitterbug sander, Russ
Dan Dowling is the one who started that finish, have shared more than one Bombay dirty martini's with the Leprechaun.
So I'm doing this with a da and I just need a 1/4 sheet electric sander? Thanks a bunch.
yes I use 1/3 sheet though. Lathe not needed just a flat surface to roll on as you push the sander down on top