Glock G40 MOS sight regulation (feedback?) - 05/03/16
Question(s) for those running the new G40 10mm:
My intended use will be boar, mostly being busted out of rocks along ridges. Running shots, in the point blank to 50 yard range. Current handgun, now retiring for G40, Bowen sighted Redhawk 44 hunter shooting 240XTP load. Last boar, typical dead run, 37 yards, one shot into vitals, and dead. On occasion, stationary boar, long shot from a steady position.
- What type of POI/POA are you seeing with the factory sights?
Blue Label guns are equipped with typical 10mm fixed sights, above the slide .165 front and .190 rear (.015" taller than standard rear). Civilian guns are equipped with adjustable. So please advise which sight, and the final measured height of the adjustable once regulated, sight in range, and load. Thanks, I will likely sight-in for a 20 yard zero, probably using a 180XTP.
If running RMR with the MOS:
- What is the measurement for the lowest sights that can be seen in the very bottom of the window?
Please advise if you are running a shim plate or not.
Thanks again, will use this info combined with my eventual results to determine needed sights. I may start off with lower sights, without RMR, then later change to taller sights, with RMR.
My intended use will be boar, mostly being busted out of rocks along ridges. Running shots, in the point blank to 50 yard range. Current handgun, now retiring for G40, Bowen sighted Redhawk 44 hunter shooting 240XTP load. Last boar, typical dead run, 37 yards, one shot into vitals, and dead. On occasion, stationary boar, long shot from a steady position.
- What type of POI/POA are you seeing with the factory sights?
Blue Label guns are equipped with typical 10mm fixed sights, above the slide .165 front and .190 rear (.015" taller than standard rear). Civilian guns are equipped with adjustable. So please advise which sight, and the final measured height of the adjustable once regulated, sight in range, and load. Thanks, I will likely sight-in for a 20 yard zero, probably using a 180XTP.
If running RMR with the MOS:
- What is the measurement for the lowest sights that can be seen in the very bottom of the window?
Please advise if you are running a shim plate or not.
Thanks again, will use this info combined with my eventual results to determine needed sights. I may start off with lower sights, without RMR, then later change to taller sights, with RMR.