Does anyone know if Tikka 595/695 bases are the same at the T3 bases? Can only find reference for the T3.
Thanx!
You might try cross-referencing #'s on the Talley website.
Thanx Sam ... But Talley doesn't list any 595/695 info on their site ... Just stuff for the T3, therefore there's nothing to cross reference. Reckon I'll have to drop'em an email and see what they say.
Warne tikka rings work perfect,I have them on my 695 ,best setup I have seen for tikka's
George, the only thing I will add is that when Beretta started importing the early t3's a lot of them were tapped metric and then they changed . Since their predecessor was the 595/695 you might want to call Talley and find out what they did.
I'm running talley's on my 595/695's, but I did call them before I ordered.
R.
Did they tell you to order the one's for the T3??
That's the rub, I can't remember! I do remember calling them, and ordering. I have them installed and they look and work great. The srcrews were a non issue. Sorry the memory is lacking, but give them a call.
I just went to their website and had a look. Under the Lightweight one piece models, they list for T3 and Master. The Master is the same as M595/M695, and that is what I called to confirm. T3/M series are the same.
R.
Thanx R ... my 595 is a Master Continental
I use the same Leo & Burris two pc bases on both
595s & T3s......usually have to run a tap in the holes to
clean out the plastic filler...6/48-32 if I recall