Guys I had a McMillan Hunters Edge made for my Nesika model T hunters action with square tang. The stock recieved from McMillan has a cutout for a round tang. Ryan said this is the way the stocks come for the Hunters Edge utilizing the Nesika action and if they were to put my rifle into a stock that they have for nesika tangs it would sit deep and below the stock in the tang area. And when I would go to cycle the bolt, the cocking piece would hit the stock preventing you from cycling it. My question is those of you that has this application(Hunters Edge etc.) what did you Guys do to the rear tang gap behind tang toward stock ie: when you bedded was it uniformative with the curve of stock, did you leave gap there and just painted over, and if you ordered stock FOR nesika action what did you do to get rear tang area flush with top of stock. Here's a link of how my tang look on the nesika action at Hendershots. I must add in the Hendershot pic showing rear tang is how I want my action to look inside stock. I didn't know I had to fill in the rear with bedding material to get this look..........look as in tang fitment being uniformative around edges without filling in. Thanks in advance.

http://www.hendershots.net/gunRoomDetail.aspx?id=2818

I've got a "T" Nesika in a classic. Mine's a swirly so I never worried about it, but if I was doin' an edge which is paint anyway and was that worried about it, I'd just fill, paint and forget... I imagine it would take about 10 minutes of effort minus dry time and that assumes drinkin' a beer while doin' it.

On your Classic Swirley was it cut out to fit your square tang or was it a round cut out mtnman1?

Trade it for a Borden action you will end up with a better fire control system and a Tang that will fit your stock,either that or get the devcon out and fill and paint,good luck!

Yes we've come to far to do anything else(trading) I'm sure it won't be a problem to fill and paint just inquiring.

yup mine was cut out for a round tang

My understanding when I spoke to Dick @ McMillan was that it's basically a remington pattern with some variances due to the nesika action. I was originally just going to order a remington pattern and Dick said there were enough variances that it was better to order specifically for the Nesika. Other than the round vs. square tang mine was a perfect fit. I think the variances are primarily around the loading port and as was mentioned around the depth. Since the edge is painted anyway, it will be a really minor fix when the tang in bedded.

Ok as per the cut out for round tang. Dick said the same as Ryan I figured it would be a easy fix once bedded just didn't won't to repaint stock rear tang area.Tell ya what I like McMillans SOO much I won't buy another Nesika for now on it'll be a Stiller, Surgeon, Borden, or one of Glen's actions . Thanks for the help Guy preciate it!!!!

Hell Glen's action is a Nesika anyway.

Yeap ur right ZERO on that one to unless McMillan get the sqaure tang programmed for their stocks to fit that action as well.