Wondering where the action strength (C model) stands, with regards to any loading I do, vs how hard I might push stuff in my bolt guns/single shots. Not looking to skirt the crazy edge with my 99. I'm just looking for some parameters/guidance for potent but reasonable, for the action.
Thanks.
For example: I also have some doubletap factory 250 loads at 2425fps, that I might consider a bit too stout.
The thing about rear locking guns is the "Spring", or stretch developed in the receiver because of the distance between lockup. If you load and work your way up, the extraction will get "Sticky" long before any dangerous level is reached. I have a .243 that acts like that with box deer loads made by Winchester and Federal. Remington is fine and is accurate, while the others fly wild (6-8 group @ 100 yards). These two are for sure loaded hotter. The lever does not get stuck in the closed position, but it is uncomfortable to work the action open.
I have loaded for my Lone Eagle and 99 in 358 for a few years now. That said I have a rule for loading. I go to the charts and locate a good looking powder ( one I have ). I note the max and beginning load. Then I use the middle or average between the two. That is MY MAX load and will be laddered up to. I usually find my best accuracy load closer to my start load. Rusty - I have my face and all my fingers - Zipper
I have loaded for my Lone Eagle and 99 in 358 for a few years now. That said I have a rule for loading. I go to the charts and locate a good looking powder ( one I have ). I note the max and beginning load. Then I use the middle or average between the two. That is MY MAX load and will be laddered up to. I usually find my best accuracy load closer to my start load. Rusty - I have my face and all my fingers - Zipper
Good advice................ There is just no need to ramrod loads in a 99. The majority of people shoot factory stuff and have no problem killing a deer or anything else for that matter. Why make things complicated and run the risk of damaging a rifle or injuring yourself?
Yeah, Have to agree to that. I have a .358 featherweight and it came with a box and a half of winchester factory ammo. Plenty of recoil there and no accuracy. I load for that one too. I believe I only own one rifle (Bolt action) that shoots really well up on the max end.
Lots of.358 data is mild, while some is stout. Just wondering where the sweet spot on pressure/velocity for 99s. Where does too much start? Thanks.