I finally managed to get in. Used to be jim island on M/T and am still Puncher on another forum.
Looking forward to picking up where I left of on M/T. By the way, I got my '95 CB in Thursday.

Jim

Hi Leprechaun,
I've been casting, this week using Lee, Lyman & Rapine moulds. I'm still a long way off from having my season supply of cast bullets but eventually I'll get there.

Had a strange happening this week, using a brand new Lee mould. After just getting the mould warmed up, the pivot pin holding the block to the handle fell out. I found it among my sprue cutoffs and put it back in place and then peened it so it shouldn't drop out again. Can't really complain though since at $17 it will pay for itself in very little time.

Glad you found this site.

Steel,
Yup, been there and done that! Had the same thing happen. "What the....?" <img src="/ubbthreads/images/graemlins/mad.gif" alt="" />

Jim