24hourcampfire.com
24hourcampfire.com
Previous Thread
Next Thread
Print Thread
Hop To
Page 3 of 7 1 2 3 4 5 6 7
Joined: Mar 2003
Posts: 17,137
Campfire Ranger
Offline
Campfire Ranger
Joined: Mar 2003
Posts: 17,137
Nice shooting for sure.


Randy
NRA
Patriot Life Benefactor





BP-B2

Joined: May 2003
Posts: 16,966
S
Campfire Ranger
Offline
Campfire Ranger
S
Joined: May 2003
Posts: 16,966

If you are serious about looking into the delta’s between 2 cartridges you also have to look at the “chamerbing” (things like how much lead area”...

It’s NOT all in the brass capacity or Neck length.... it’s in the Twist & lead spec’s as well... but those are in the “chambering” side of the equation, NOT the brass side.

Joined: Jul 2001
Posts: 59,910
M
Campfire Kahuna
Offline
Campfire Kahuna
M
Joined: Jul 2001
Posts: 59,910
I have been fooling with both the 6.5 GAP and 6.5 PRC this year quite a bit. One of the more interesting results involved measuring the water capacity of each case with the same 143-grain Hornady ELD-M bullet seated to the "standard" overall cartridge length. In the GAP 4s this was 2.85 inches (to fit in the standard short-action magazine), and in the 6.5 PRC 2.95 inches, the maximum SAAMI overall length.

The H20 capacity in both, using fired Hornady cases, was within a couple 10ths of a grain. While the GAP case body is wider, it's shorter than the PRC's body. According to the laws of interior ballistics, what one will do, the other will as well.

Now, if bullets are seated out another .1 inch in the GAP, it gains 1.3% more case capacity. Since any difference in capacity results in about 1/4 as much difference in potential velocity, given the same pressures and barrel length, this gives the 6.5 GAP about a 10 fps advantage in loads getting around 3000 fps.


“Montana seems to me to be what a small boy would think Texas is like from hearing Texans.”
John Steinbeck
Joined: Nov 2006
Posts: 2,884
R
Campfire Regular
Offline
Campfire Regular
R
Joined: Nov 2006
Posts: 2,884
could the PRC be built off a WSM action?

Joined: Oct 2009
Posts: 5,197
Campfire Tracker
Offline
Campfire Tracker
Joined: Oct 2009
Posts: 5,197
Originally Posted by RHutch
could the PRC be built off a WSM action?


Yes.


Luck....is the residue of design...
[Linked Image]
IC B2

Joined: Oct 2009
Posts: 5,197
Campfire Tracker
Offline
Campfire Tracker
Joined: Oct 2009
Posts: 5,197
Originally Posted by oldslowdog
Impressive shooting for sure. Never knew it got dead calm in your part of the world.

But the big question is have you got a leather cheekpiece designed for the EH1 yet?

I know it would shoot better.....

smile


I need about 40 hours in a day instead of 24....;)


Luck....is the residue of design...
[Linked Image]
Joined: Oct 2007
Posts: 1,871
Campfire Regular
Offline
Campfire Regular
Joined: Oct 2007
Posts: 1,871
Originally Posted by scenarshooter

I need about 40 hours in a day instead of 24....;)


Well, you clearly don't need to spend any extra time shooting.

I think you have got that down.

smile

Joined: Jan 2008
Posts: 707
M
Campfire Regular
Offline
Campfire Regular
M
Joined: Jan 2008
Posts: 707
Pat, are you running H1000 or R26?

Joined: May 2007
Posts: 3,943
Campfire Tracker
Offline
Campfire Tracker
Joined: May 2007
Posts: 3,943
Can a 6.5 PRC be built off of a WSM action?

Yes,it can,but it's a good idea to make sure your WSM has enough magazine length. The WSM actions that work without modification include The Winchester M70,the KImber 8400 and the Montana Rifle Company action.

Remington WSM actions and clones need a magazine box to work. Not sure about others,Pat and Mule Deer may know more about other suitable actions.

Last edited by ruraldoc; 09/26/18.
Joined: Dec 2007
Posts: 16,112
Campfire Ranger
Offline
Campfire Ranger
Joined: Dec 2007
Posts: 16,112
The WSM case is .555" at the web, the SAUM's are .550", and the PRC is .532", I'm going to say, as for 700 actions, you need to start with a regular magnum action to feed the PRC from a BDL bottom metal set up, as will a WSM/SAUM needs to begin with the larger action or open up the feed rails to accommodate the bigger cases.

Detachable bottom metal changes things though.......

IC B3

Joined: May 2007
Posts: 3,943
Campfire Tracker
Offline
Campfire Tracker
Joined: May 2007
Posts: 3,943
In the case of a M700,the PRC will not work from the regular BDL/ADL magazine set up. The overall length is about 0.1 inch too short. You must change to an aftermarket magazine box to use the longer PRC cartridge. Once you do that,the M700 Short Mag action should work fine.

I think that Mule Deer mentioned in another thread that he was planning on doing that very thing.

Last edited by ruraldoc; 09/26/18.
Joined: Dec 2007
Posts: 16,112
Campfire Ranger
Offline
Campfire Ranger
Joined: Dec 2007
Posts: 16,112
Sorry, should have clarified. SAAMI has PRC OAL at 2.955", so a short action is out, so you're correct, unless running a Wyatts box. I built my PRC on a long action 700 with BDL bottom metal that worked just fine.

https://saami.org/wp-content/uploads/2018/07/6.5-PRC-Public-Introduction-6-28-2018.pdf

Joined: Nov 2009
Posts: 6,842
R
Campfire Tracker
Offline
Campfire Tracker
R
Joined: Nov 2009
Posts: 6,842
What powder do you'all recommend for the PRC, I have found R-26 gets a little pumped up in the heat of S. Texas, in my 6MMs ? Rio7

Last edited by RIO7; 09/26/18.
Joined: Dec 2007
Posts: 16,112
Campfire Ranger
Offline
Campfire Ranger
Joined: Dec 2007
Posts: 16,112
H-1000

Joined: Nov 2009
Posts: 6,842
R
Campfire Tracker
Offline
Campfire Tracker
R
Joined: Nov 2009
Posts: 6,842
aalf, I have noticed in the 6mms H-1000 is really slow, I have H-1000 I will give it a go, what's your take on Retumbo? it works great in my 6s. Rio7

Joined: Dec 2007
Posts: 16,112
Campfire Ranger
Offline
Campfire Ranger
Joined: Dec 2007
Posts: 16,112
I like Retumbo, but have never used it in "smaller" cartridges.

Joined: Dec 2009
Posts: 4,636
Campfire Tracker
Offline
Campfire Tracker
Joined: Dec 2009
Posts: 4,636
Originally Posted by scenarshooter
Originally Posted by oldslowdog
Impressive shooting for sure. Never knew it got dead calm in your part of the world.

But the big question is have you got a leather cheekpiece designed for the EH1 yet?

I know it would shoot better.....

smile


I need about 40 hours in a day instead of 24....;)


Pat, why don’t you make a short mag cartridge carrier while you’re at it!


Originally Posted by shrapnel
I probably hit more elk with a pickup than you have with a rifle.


Originally Posted by JohnBurns
I have yet to see anyone claim Leupold has never had to fix an optic. I know I have sent a few back. 2 MK 6s, a VX-6, and 3 VX-111s.
Joined: Oct 2009
Posts: 5,197
Campfire Tracker
Offline
Campfire Tracker
Joined: Oct 2009
Posts: 5,197
[Linked Image]

Just rolled in from another "field session"

Early on it was mostly calm, and 37F. That was short lived. A strong headwind from the northwest came up after 1/2 hour or so. There was a "push", right/left, no mirage....


[Linked Image]

First ten shots...I wanted to see how it would do when it got hot, and I wasn't disappointed.



[Linked Image]

After letting it cool, I fired these two at the next plate after adjusting up 6/10ths....

More to come....


Luck....is the residue of design...
[Linked Image]
Joined: Oct 2009
Posts: 5,197
Campfire Tracker
Offline
Campfire Tracker
Joined: Oct 2009
Posts: 5,197
[Linked Image]

Next, I went to 895 meters. By now it was blowing pretty good. I really wanted a first round hit on this one. I put in 5.8 mils, held off 8/10ths, and made my first round hit.

Next two, I held 9/10ths....grinning from ear to ear....;)

The barrel now has 351 rounds through it. Should be stable now.


Luck....is the residue of design...
[Linked Image]
Joined: Oct 2009
Posts: 5,197
Campfire Tracker
Offline
Campfire Tracker
Joined: Oct 2009
Posts: 5,197
[Linked Image]

As an interesting footnote, I'd cleaned the barrel at 75 rounds, so it hadn't been cleaned in 276 rounds. I started with a wet patch, soaked with Butch's Bore Shine, made five passes with a 6.5 bronze brush, two clean patches,

two more soaked patches, then a couple dry ones....zero copper, and not much powder...

Bartlein barrels are pretty good...;)


Luck....is the residue of design...
[Linked Image]
Page 3 of 7 1 2 3 4 5 6 7

Moderated by  RickBin 

Link Copied to Clipboard
YB23

Who's Online Now
337 members (280shooter, 204guy, 29aholic, 10gaugemag, 1beaver_shooter, 16penny, 44 invisible), 2,235 guests, and 1,082 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums81
Topics1,187,724
Posts18,400,607
Members73,822
Most Online11,491
Jul 7th, 2023


 







Fish & Game Departments | Solunar Tables | Mission Statement | Privacy Policy | Contact Us | DMCA
Hunting | Fishing | Camping | Backpacking | Reloading | Campfire Forums | Gear Shop
Copyright © 2000-2024 24hourcampfire.com, Inc. All Rights Reserved.
Powered by UBB.threads™ PHP Forum Software 7.7.5
(Release build 20201027)
Responsive Width:

PHP: 7.3.33 Page Time: 0.116s Queries: 14 (0.003s) Memory: 0.9065 MB (Peak: 1.0395 MB) Data Comp: Zlib Server Time: 2024-03-29 05:04:23 UTC
Valid HTML 5 and Valid CSS