Home Forums Reloading Bullet Casting Evaluation of Locking Handles for Casting Moulds

The subject article was published in the August edition of The Single Shot Exchange Magazine. For those of you that don’t subscribe to the magazine click on the link below.
http://www.texas-mac.com/Evaluation_of_Locking_Handles_for_Casting_Moulds.html

Wayne

A fine article Wayne. I thought of locking handles once & thought I could do the same on my cooling stand with a stop & 2 nails. Never got round to it. If I was casting large bullets like you do especially using more than one mould [like you state in the article] I would try some type of locking device for the cooling mould.

Again, great article.