|
Joined: Feb 2011
Posts: 338
Campfire Member
|
Campfire Member
Joined: Feb 2011
Posts: 338 |
I have one in 450 Marlin with a 2-7 atop it. Handy, well balanced and downright fun.
"Think about how stupid the average person is, and then think that half of the people are stupider than that" - George Carlin
|
|
|
|
Joined: Jan 2016
Posts: 1,227
Campfire Regular
|
Campfire Regular
Joined: Jan 2016
Posts: 1,227 |
I have a BLR circa 1971 in .243. It is a little heavy for a lever action and the trigger could be better but it is a good rifle for deer and javi.
|
|
|
|
Joined: Dec 2010
Posts: 1,606
Campfire Regular
|
Campfire Regular
Joined: Dec 2010
Posts: 1,606 |
Bocajnala, I'm a lever guy too. I have hunted in Alaska with a blr in 358 since 2005 and with a Savage 99 in 358 since 2011. Like you, I've owned marlin, Henry, Winchester and Savage lever guns. I'd take a good BLR over any Marlin or Savage 99. They're lighter, and tougher. I recently tested the BLR against the 99 with over-pressure rounds. Enough pressure to cause case head expansion and loose primer pockets. Far before loose primer pockets, the Savage 99 extractor bent outward and slipped over the case head. The BLR extractor extracted like a dmn Mauser claw. On the last and final round where I encountered the only loose primer, I had to lean the stock against my thigh, and pull the lever for all I was worth. Extracted like a champ. No problems with the strength of the gearing, the aluminum receiver, or the extractor. No damage to the rifle. Iregardless of what you might read from others, the BLR is the first rifle that convinced me that some push feed guns will extract and eject as well as my Mauser. During winter testing as cold as 38 below (ambient), the BLR firing pin was flawless, even with an action chock full of cheap gun oil.
|
|
|
|
Joined: May 2016
Posts: 1,408
Campfire Regular
|
Campfire Regular
Joined: May 2016
Posts: 1,408 |
I have never gone to the point that Mainer did, but full pressure loads were flawless in the BLR, extraction was quite easy. My hunting loads are full pressure . It is a gear operated bolt action rifle. Obviously it can be somewhat more difficult to extract than a turn bolt . I now have 3 of them, I also went from the Marlin 1895 45/70 to a BLR .450 because I had not fully trusted the action of the Marlin. Great post Mainer
|
|
|
|
Joined: Nov 2006
Posts: 10,772
Campfire Outfitter
|
Campfire Outfitter
Joined: Nov 2006
Posts: 10,772 |
My brother has had one, a .308, since the 70’s sometime. It’s almost the only rifle he ever uses. When he first got it I developed loads for it and was shocked at how well it shot. He’s taken it all over for elk, moose, caribou...what have you. One of our best friends got the same thing about the same time and, he too, has used almost nothing else for 40 years or so.
It was mentioned above that they can be tricky to work on. I’ve had both those rifles apart a few times over the years and that’s true. Almost every time it was a matter of their having been jammed to a standstill by a surprisingly small piece of debris, a piece of twig, a leaf stem...something like that. That would be my primary concern with them.
Personally, I like lever guns, have some Marlins, Savages, Winchester’s, but I never cared much for the looks of the BLR. Then again, I don’t think Browning’s made a rifle I like the looks of in a long time.
Mathew 22: 37-39
|
|
|
|
Joined: Feb 2004
Posts: 7,731
Campfire Outfitter
|
Campfire Outfitter
Joined: Feb 2004
Posts: 7,731 |
The straight stock short action models fit me perfectly. I’ve had three and 2 were moa shooters the third a 1.25-1.5moa all with factory loads. They carry well and with a 2.5-8x36 Leupold they were just about perfect for the short range stalk hunting I do and held their own when I hunted out of a box blind overlooking greenfields. I’ll own another one someday. FWIW the long action models do not fit me well at all. I’m 6’3 🤷🏼♂️
Last edited by 444Matt; 03/23/19.
|
|
|
|
Joined: Sep 2007
Posts: 3,612
Campfire Tracker
|
Campfire Tracker
Joined: Sep 2007
Posts: 3,612 |
Just shot my BLR in 358 Win today for the first time since last fall and it was still a lot of fun to shoot With the right loads it's capable of shooting under moa, nothing that good today but I was rusty after the long winter. Would gladly own another.................
Gerry.
|
|
|
|
Joined: Feb 2018
Posts: 369
Campfire Member
|
Campfire Member
Joined: Feb 2018
Posts: 369 |
I have a 308 with the straight grip stock. It’s a good gun, mine will shoot about an inch and a half at 100yards. Fairly lightweight and looks nice. The trigger is awful though, depending on how you hunt, you may never notice it in the field, but every time I go to the range it drives me crazy. Also, I put a 3-9x40 on it and wish I’d gone smaller.
|
|
|
|
Joined: May 2017
Posts: 1,048
Campfire Regular
|
Campfire Regular
Joined: May 2017
Posts: 1,048 |
I’ve always wanted one. Picked up an early 80’s model ‘81 7mm-08 just last week... I was getting light strikes and it was pissing me off. It had never been taken down before. I was pretty intimidated about doing it but I stripped it down, took the bolt apart, cleaned it real well and put it back together. I’m not suggesting every body do it, but anybody with some mechanical inclination and the right punches can do it. I got to spend some trigger time with it this afternoon... it’s shooting great, the light strikes are gone, and it’s been a long time since I’ve had so much fun just shooting a gun. Mine was holding 1.5ish MOA with the first batch of ammo I made. I know I can shrink that down a bit but doubt I’ll worry about it. That is plenty good for busting hide to 350 and under.. I’m looking forward to many years of enjoyment with this little unit.. Good luck, Todd
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
162's at 2550fps from a 20" spout,prolly do not suck. It'll ring 1000yd steel,with boring regularity ala the windshield alone and is easily amongst my FAVORITE Sleepers and oh how I do love me some Sleepers.(grin) Pass the Steel and rigid frame. Hint................
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
Joined: Oct 2008
Posts: 7,263
Campfire Tracker
|
Campfire Tracker
Joined: Oct 2008
Posts: 7,263 |
If I wanted a lever action for accuracy this is probably where I would start and probably stop. The BLR is like an artillery rotary bolt action more than most other lever actions.
Too bad about the triggers and limited options on getting it tuned up but the steel frame short actions are a pretty nice combo. I have owned 243s and 308s but one in 358 or 284 has always had my interest just haven't run into one at a steal of a deal yet. Same for one in 22-250 or 257 Roberts. There will probably be more BLRs in my future, I hope so.
So for the OP get it if you haven't already.
"When you disarm the people, you commence to offend them and show that you distrust them either through cowardice or lack of confidence, and both of these opinions generate hatred." Niccolo Machiavelli
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
Hardly "daunting" to stone the trigger. Hint. Congratulations?!?
I very much enjoy the exceedingly long list of things,that you can't do. Hint.
Bless your heart.
Hint.
Laughing!.....................
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
Joined: Jul 2015
Posts: 14,640
Campfire Outfitter
|
Campfire Outfitter
Joined: Jul 2015
Posts: 14,640 |
I very much enjoy the exceedingly long list of things,that you can't do. Hint.. Yes, it is soooo pathetic that he can't dangle his feet from a nickel or break an anvil. Or ruin a Geissele.
Politics is War by Other Means
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
I very much enjoy the exceedingly long list of things,that you can't do. Hint.. Yes, it is soooo pathetic that he can't dangle his feet from a nickel or break an anvil. Or ruin a Geissele. Trybone, "Luckily" you "get" to read about it and "live" vicariously,as you GREEDILY consume every word and Splendid Pixel...you "lucky" kchunt. Hint. Congratulations?!? You couldn't "critique" a ZipLoc sack. Hint. Bless your heart for crying though. Hint. Laughing!..................
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
Ooooopsie!..............
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
Joined: Dec 2010
Posts: 1,606
Campfire Regular
|
Campfire Regular
Joined: Dec 2010
Posts: 1,606 |
My BLR has a superb trigger right out of the box. Crisp and right at 4lbs on the trigger scale. Due to the wide trigger, 4lbs doesn't feel like much. Not all of them have bad triggers. 300-400 yds shots, the 4lb trigger hasn't effected accuracy. I also don't want it any lighter, so probably will never fiddle with the hammer spring. I want that hammer to slam home at 40 below. On exposed hammer guns like levers and revolvers, I'm leery of anything lighter than 4 lb trigger pull in the cold weather. I replaced the hammer spring and trigger return spring on my sp101 with a Wilson set. As the springs broke in, I began getting misfires in the cold weather. ISMI springs fixed the problem, and never break in or weaken over time, but are lighter than stock springs. They're not cheap music wire, can't remember what the composition is, most of their customers are high RPM race engine builders who need better valve springs. After working out any trigger creep issues, if trigger pull is over 4lbs, maybe give ISMI a call. Any time I need lighter springs, I get replacements from them. Don't cut a coil off the hammer spring. I learned the hard way that making the spring shorter for a lighter pull, isn't the best idea in cold weather. https://www.ismi-gunsprings.com
Last edited by mainer_in_ak; 03/25/19.
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
I shoot the above at 900yd steel,all the time and it's funny to watch folks respond to same.(grin)
Prolly don't take all that much time either,to simply gawk the reticle and connect dots,as per whim.
Hint....................
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
Joined: Jul 2015
Posts: 14,640
Campfire Outfitter
|
Campfire Outfitter
Joined: Jul 2015
Posts: 14,640 |
Ooooopsie!.............. Oh, it's in pieces. What a surprise!
Politics is War by Other Means
|
|
|
|
Joined: Jan 2001
Posts: 58,242
Campfire Kahuna
|
Campfire Kahuna
Joined: Jan 2001
Posts: 58,242 |
Trybone, How else might one tune the trigger,replace broken guts and throw a new spout aboard? Hint. Congratulations?!? You Drooling DUMB Fhuqks are a Whining Hoot! You'd need a Co-signer,for the paint alone! Hint. Here's to the perpetual HILARITY,of you doing your very BEST. Hint. Bless your heart for crying. Hint. LAUGHING!...............
Brad says: "Can't fault Rick for his pity letting you back on the fire... but pity it was and remains. Nothing more, nothing less. A sad little man in a sad little dream."
|
|
|
|
599 members (11point, 007FJ, 10ring1, 10Glocks, 1234, 10gaugemag, 65 invisible),
2,583
guests, and
1,341
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
Forums81
Topics1,190,432
Posts18,451,155
Members73,901
|
Most Online11,491 Jul 7th, 2023
|
|
|
|