Home Forums Hunting & Shooting Rimfires CZ Brno Model 1 scope rings

Not sure how relevant this is, but when I bought a new 455 some years ago, ordered a set of B Square adapters that fastened into the dove tail w/set screws, so I could use standard one inch Burris rings. Worked fine for me.

JSTUART -

1. Nice setup. What mag is that Zeiss?

2. Have you ever tried Talley 527 mounts on that rail?
I'd spring for a set but I don't know how deep the rail slot is on that product, and I don't really want to get into reblueing if they need to be modified.

10x

No, I do not particularly think much of Talley mounts, others may like them but that is on them.

I'm trying to keep my rifle slim and light so I'm thinking about Talleys, at least if can't get originals.

I definitely DONT like the vertical split aspect.

The medium height SportsMatch rings finally arrived from across the ocean. They are a very good fit on the 15 mm Model 1 dovetail. These are well made steel rings, not light duty rimfire rings. They seem higher than usual for medium height rings. Cost shipped was $43. The folks at ANT Supply were very helpful. I’d not hesitate to do business with them again.

I used Conetrol Daptar set-up onna Brno # 1.