found the oil leak on my 12 valve after I took it to the car wash and cleaned the engine off, going to have to pull the vacuum pump and rebuild it. Cummins wants 60 bucks for the seal kit, found it on amazon for 25 prime so no shipping, even 25 is high for damn O rings.
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
The damn thing has been leaking oil for months and couldn't figure out from where till I cleaned and got under there with a flashlight while it was running.
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
there is a seal that is not an o ring in the kit. the one I order comes with the new seal that rides on two areas of the shaft instead of the one that the original seal rode on encase the shaft has a slight groove worn in it.
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
Amazin that we were able ta repair anything BITD, with just a Chilton manual.
ha
Originally Posted by Fubarski
Amazin that we were able ta repair anything BITD, with just a Chilton manual.
have several here at the house but the videos are much better.
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter
have only had to do the suspension and replace the gear case because of the killer dowel pin so far, which was a problem on all 12valve Cummins. these vacuum pumps need to be rebuilt about every 150000-200000 miles from what I read, the engine runs great. fixing to hit 200000 miles. so in reality not many repairs. I did put a new radiator in also.
God bless Texas----------------------- Old 300 I will remain what i am until the day I die- A HUNTER......Sitting Bull Its not how you pick the booger.. but where you put it !! Roger V Hunter