Home Forums Hunting & Shooting Gunsmithing Oval rings needed for sling installation

Hey all,

So, I inherited my dad’s custom built 3006 that was made in the 1960s on an unknown Mauser action. Some time in the past, before I got it someone took the sling off of it. When the did, they also took the rings that the sling installed with. Regular sling swivels don’t work. I am going to need to get the oblong rings and mount them back on the rifle. Then feed the sling through the oblong ring.

So, any ideas on where to find these rings and the best way to mount them. I am assuming they need to be no welded.

Thanks,

DR

The Blue State spineless sheep in OR at GrovTec manufacture sling attachment hardware.

Ahh yes, Mr personality strikes again

Can you replace the studs with ones that QD swivels will go on?

No, I hope I could but the “bases” are actually recessed into the wood of the stock.

It must SUCK to be surrounded by the spineless sheep in your Blue State of Mn & adjacent states on Blue Fame in MI,WI,IN,IL.


Standing Fast & Firm.

Oh yea...G.F.Y.

Do you have any idea about the real world? 'nuf said here!

Yes,but apparently YOU need to pull your head out to see the light.
Typical spineless Dem response-play dumb...it fits the mentality.

And once again your shining personality takes center stage!

You obviously have no idea what my political orientation is.

My Daddy said never argue with an a$$hole; people might not know the difference.

I looked in my sling drawer and found 1 that looks somewhat like that. However You may be able to bend a ring to fit that.

I will wait your email pictures tomorrow.

Email pictures sent