Home Forums Hunting & Shooting Hunting Rifles Kliengunther bases

Hello I am looking for scope bases for a seguin Texas made kliengunther. These were made after he left kleinguenther arms, the holes are two along the barrel near the safety and horizontal to the barrel near the front of the muzzle.

Please advise if you would be so kind.

Thanks
John

I had the same issue with my Voere, who supplied the actions for kleingunther. You basically have three options.

1. Find a vintage redfield 1-piece mount. Not too hard. There are several on ebay.

2. Get a set of cone-trol bases and rings. Expensive, but seamless and very high quality.

3. Get a blank set of bases and have them machined.

I went with cone-trol since I prefer two piece bases. No complaints with them.

Small ring Mauser bases fit Kleinguenther. I put Talley bases and rings on mine. I’d post a picture, but it’s very slow this am

I made a 1 piece rail for mine, easy project if you have a mill.... outside of that I think all the options have been listed. Good luck

I bought the budget redfield one piece.

If I don't like it I will go conetrol.

Thanks!