This thread has me regretting tossing two rusted out barbecues into the appliance pile at the dump. Should have at least cannibalized one valve, right?
Up hills slow, Down hills fast Tonnage first and Safety last.
I built my own with directions from these DIY instructions, I have a total of $74 in the build and it works fantastic. I did make 2 turntables for small and large cases
I’ve been using the UGLY fairly hard the last week and really like it. I was able to put 262 223 brass in the hopper and could have stacked in some more but that was all I had in front of me. It takes a little time to load but it’s completely hands off after it starts.
450BM—After weeks of procrastination, my Ugly Annealer is inbound and due to be delivered on Sunday. I’m hoping that setup goes as smoothly as yours did.
I bought an Ugly Annealer a few months ago. That is one bad arse machine! Built like a tank. Very easy to set up and get going. Lots of videos on you tube if needed