This started out as a 7.62x39 barreled action when Brownell's had them on sale a couple years ago. Had 'smith Ray Montgomery (Grand Junction) put a threaded Douglas barrel on it in 22PPC. Put it in a Boyd's AT1 stock and trigger springs to make the trigger break at 1.2 pounds. Less than 700 rounds (never hot loads nor heated up). Will routinely shoot sub .50 groups. Am thinning my herd of PD rifles. Will include RCBS dies, scope bases (rings and scope not included). $675 shipped (CUSA) to FFL that accepts from individual.

https://imgur.com/a/waO2fXN

https://imgur.com/a/RxQorD2

Need an 'I'll take it' followed by a PM with all contact info. USPS M.O. or personal check from established 'CF member.

NOTE: As Pappy348 mentioned, it has an upgraded DIP triggerguard.

So, how do you like that DIP guard? I’m considering one for my Carbon Stalker?

Already have one of Wayne York’s floorplates, but think the mag might be easier for a rifle that will get a good bit of range time.

THX

🔝

Interested,what twist?
8325284472 for quicker response

The DIP triggerguard is an improvement over the factory version, that's for sure. It's a Douglas air gauged barrel, threaded 5/8x24. I believe it's a 1-12 twist as I run all 50-55 grain bullets. As I said it shoots great.

Besides the dies will also include ~85+ fired cases.

Was asked what it weighs: near as I can tell on bathroom scales it weighs 8.75 without scope/rings (they aren't included). The action was also professionally glass bedded.

Will take this for $675. PM inbound.

SPF to Ben Lurkin