Helping a friend get set up in reloading. Looking for a non-aluminum single stage press (turrets considered), 25-06 brass and maybe 45ACP carbide dies.

Tag

I have a Lyman Orange Crusher Press and 21 pieces of 25-06 Brass.
PM me a cell phone number for Pics and we can talk .
Rich

I have a few pieces of 25-06. Same as Rich, send me a PM with a number and we can talk.

Pm sent. Also, when you get your press and som 25 dies, run 30-06 through them and make your own. Easy peasy.

.270 are easier to size down.

270s might be easier but 30-06 headstamps are way cooler 😎

Plus you'll more than likely be trimming when it's said and done with a 270.
06 cases go in one pass to 25, may have to bump the shoulder a tick then load and rock on

Generally 270 brass is easier to find and cheaper, but I want to keep him with the proper h-s if at all possible. The 270 will need trimming, but the 30-06 might need neck turning.

I have a rock chucker I’m not using

What's the cost to get it to me? 82435

I have brass, bullets, and even a couple of boxes of factory ammo available.

I'm full up on brass, if all that is coming is coming