This is the pre-season batch. If you're not familiar, here's the story: Modified Talley's for Tikka T-3's

I have 1" Lows, 1" Mediums, and 30mm Lows. Lows will put the tube .410 off the top of the receiver, Mediums .507. One base screw will be slightly shorter than the others and goes in the receiver hole over the bolt head.


$63/TYD

(slightly higher than before, sorry about that)

If you already have set and want them milled, it's $30/TYD.


1" Lows with 6x42




1" Mediums with 6x42



30mm Lows with SWFA 10X (This set up is sweet, BTW. MQ is the way to roll though)

Before and After, mediums IIRC

Currently 11 sets of these in use on my Tikka's ....Zero failures with the rings or the customer service

X-lows milled and a Burris 3X9X40....perfection

Damn man, I'd lost count....

Daggum, Mitch. That's a close fit!

Russell

Tag

also

Bumper....

Pm incoming

will take a set of the medium, will pm info

Can you do it for sako 75/85 I would love these on my rifles please p.m with answer

Bump for a good guy doing great work. Mine are perfect.

Hey ol buddy, that looks like the Cabelas Superlite Stainless version...

I recently picked up a NIB one in 7mm Rem Mag that I haven't shot yet.

I believe I'll go with that extra low set up!

Received my rings yesterday and the fit perfect. The front screw that needed to be shortened was perfect also.

tag