Remington Model 7 xcr 7mm08, gun is stainless but has been cerakote coated by Whiddon gun works. Bolt has been spiral fluted and bolt handle has been skeletonized by Kampfiield customs. Stock has been replaced with a H&S precision stock, green with black webbing with aluminum bedding block and skim bedded by Whiddon gun works. Trigger has also been replace with a shilen trigger also by Whiddon. Talley 30mm rings with a Minox ZA5 HD 3-15x50 scope. The gun has spent most of its life in the safe. I can email pictures. I’m having trouble getting them to load on here.. There are a couple small marks on the trigger guard and floor plate that I saw when taking pictures.. I also saw a ring mark on scope I have pictures and can text or email them. I’ll throw in a set of rcbs dies and what brass I have..
Asking 1550.00 obo


https://www.24hourcampfire.com/ubbt...62/re-remington-model-7-xcr#Post12226062

I tried to get the pictures to up load with no luck for 30 minutes This is a post where I had it for sale in the past. The gun has sat in the safe since I took those pictures..

Thanks all
Scott

Bump for price change..

PM SENT

Nice shooting iron, GLWS!

Like to had it,if it was still stock like you bought it

I too would have liked to see it in the original tri-nyte coating - I'm sure cerakote is "mo betta"- but much of the interest in a model seven xcr is that coating.

GLWYS - and that is a nice stick!

Price without the scope & rings?

All pms answered, thanks for everyone’s input and compliments.

Reeder I sent you a pm.

Thanks all, Scott

How about 1500.00

How about 1475.00

1450.00

Nice rifle, what does it weigh?

I’m not sure, I’ve never weighed it..

Btt

Bump

Nice rig!

Thanks 16bore

Bump

Nice one for someone

I refuse to open this again...

👍

I'll take it per our PM's.

Keith

Ok, whats wrong with it?

It’s sold thanks..

Thanks Ramblin99 !! I hope you enjoy it!!