Browning Maxus Problem - 01/11/20
I’ve had my Maxus for a little over a year now. This season is the first that it’s seen a lot of use and I’ve had some issues in my past 2 or 3 hunts.
It’s having trouble cycling the 2nd and 3rd shells. I have no issues with ejection or extraction. I’ve checked the piston spring and it’s fine. I clean my gun after every single hunt so I know that the issue is not that it’s too dirty.
I believe my issue may be with the lifter. When I look underneath the receiver the lifter arm is all the way against the inside wall of the receiver. When I look inside the receiver close to where the shell loads I can see something that looks like a wear mark from the lifter arm.
It will cycle fine until I fire 10 shells or more and then it really slows down and starts to hang. Has anyone else experienced anything like this in your Maxus?
It’s having trouble cycling the 2nd and 3rd shells. I have no issues with ejection or extraction. I’ve checked the piston spring and it’s fine. I clean my gun after every single hunt so I know that the issue is not that it’s too dirty.
I believe my issue may be with the lifter. When I look underneath the receiver the lifter arm is all the way against the inside wall of the receiver. When I look inside the receiver close to where the shell loads I can see something that looks like a wear mark from the lifter arm.
It will cycle fine until I fire 10 shells or more and then it really slows down and starts to hang. Has anyone else experienced anything like this in your Maxus?