Full length bedding a Kimber Montana - 10/21/17
Has anyone seen any dramatic improvements by full length bedding a Kimber Montana? My 7mm-08 is shooting right at MOA since I bedded it. I stopped at the end of the barrel shank though and I was considering trying a full length bed.
Is this hard to get right? Is it more complicated than a good tape and release agent job with a squared up piece of clay at the end of the stock to act as a dam?
On one hand I might need to leave well enough alone. On the other hand I want to see if it helps and don't see why I couldn't easily get rid of it if it is worse.
I would be using Pro Bed 2000 that I have on hand.
Is this hard to get right? Is it more complicated than a good tape and release agent job with a squared up piece of clay at the end of the stock to act as a dam?
On one hand I might need to leave well enough alone. On the other hand I want to see if it helps and don't see why I couldn't easily get rid of it if it is worse.
I would be using Pro Bed 2000 that I have on hand.