We have a Ruger Model 77 with the milled receiver. Is there a picatinny rail available for this application?Thanks for any help! memtb

There's an EGW option that requires D&T. The receiver are dang hard but doable at home, or via a smith. I did it a couple of times and would plan on 4 taps for the four holes. Following advice I saw on Brownell's I used HSS taps so broken ones could be chipped out as needed. There's a clamp on unit, called a Wiggitinny? that I have not personally used, nor heard much good about that uses Ruger-like mounting. YRMV.

They end of higher than I like BTW.

Look at this:

https://www.jackweigand.com/Ruger-M77-MKII-Rifle-Scope-Mounts-No-Drill.html


I have one on a Hawkeye. (Top rifle)

https://www.kenfarrell.com/index.php?route=product/product&product_id=304

These and a drill mill and you will be in business.