Looking to have one of my interarms actions rebarreled to 375 ruger. I already have a barrel, stock and all components. I just need the barrel chambered, and the stock bedded. Who do you guys recommend to do the work?
Dennis Olson in Plains, MT is my go to for work like that.
Pretty straight forward job for me
Out of curiosity Jim, what do you do for the magazine, feed rails, etc. Since the geometry of the stacked cartridges differs from say the 338 Win Mag which is roughly the same length case?
I'd recommend jkob as well...
Pretty straight forward job for me
You won't go wrong going with him! Not many old school smiths these days.
Rex
Pretty straight forward job for me
One more recommendation for Mr. Kobe...
416 Ruger underneath a Whitworth 375 H&H.
Just completed a 375 Ruger for a customer and liked it so much I built mysef the 416 Ruger.
416 Ruger underneath a Whitworth 375 H&H.
Just completed a 375 Ruger for a customer and liked it so much I built mysef the 416 Ruger.
I was under the impression you were retired?
That is true, I was speaking in the past tense. I should have said, I had just completed the .375 and liked it so much... This was several years back. 2" more barrel than the Whitworth and lighter to boot. A fine cartridge.