Cleanup - 10/15/09
One of the most oft used rationalization for not shooting bp is the " hard to cleanup" talking point.
Well its not that hard.
Push a dry patch on a jag down the bore. Follow with a couple of damp (not wet, plain water will suffice) , then a dry. If the dry shows powder fouling repeat the damp . After the clean dry patch comes out, if there's no leading trace, use that same dry patch with your favored oil (3n1,Ballistol,remoil....) to run thru the bore and your done.
Case cleanup is just as simple.
Punch the primers (or not) put the cases in a jug of water with detergent/soap (oxyclean,simplegreen,dawn,tide,,,,) shake them around until the water is black, lay them out to dry. When they're dry you can choose to load again (or if you don't like grungy ugly cases) run them thru the "tumbler"
Takes about as long to read this as it does to do it.
Well its not that hard.
Push a dry patch on a jag down the bore. Follow with a couple of damp (not wet, plain water will suffice) , then a dry. If the dry shows powder fouling repeat the damp . After the clean dry patch comes out, if there's no leading trace, use that same dry patch with your favored oil (3n1,Ballistol,remoil....) to run thru the bore and your done.
Case cleanup is just as simple.
Punch the primers (or not) put the cases in a jug of water with detergent/soap (oxyclean,simplegreen,dawn,tide,,,,) shake them around until the water is black, lay them out to dry. When they're dry you can choose to load again (or if you don't like grungy ugly cases) run them thru the "tumbler"
Takes about as long to read this as it does to do it.