Decided to put dump bed on my 2011 Ram 3500...

Flat bed with Reese stakes (forklift load from the side kinda thing w/o the stakes).

This is my 1998.5 version...

3 tons with dual airbags... onboard air compressor et al...

Anyone have a set of drawing they have used in the past... or know a fabricator around Richmond, VA?



Thanks

That one goes up a lot higher than many I've seen. Many don't go higher than 45 degrees. 45 will dump marbles and water but not much else. Dirt or sand won't slide at that angle.

I like it. I need at least 5 ton capacity but that dodge is nice