Good info so far.
Being that I tested our service rifles off the bags, the handguards were not all that slick....
I ended up best with the front rest soft, and up against the mag well basically.
Wrap up wiht the gun, get square behind it, and don't worry about the tip of the trigger finger, put the finger where it rests naturally, wherever that is, and squeeze the trigger and ride the sights back to the bull...
Granted getting groups under .5 moa ish was a tough chore, but I think thats pretty good for service rifles.
I finally had a test bed upper made, slick flat bottom, to put new barrels in, do the load work, then reassemble...to service rifle, it usually told the truth too and was much easier to shoot.
