For sale- 6mm Crusader built by Nathan Chesney of Hillbilly Custom Rifles
Defiance Short action with guardian magwell, accepts AI or AW mags, comes with one of each, but in this chambering, the AW does not work with more than 5 cartridges, but would work great if re-chambered or re-barreled to something on a 308 based cartridge. 20 MOA rail. This action is the same as the GAP Templar
Defiance DBM- spring loaded with push button inside trigger guard
27" Bartlein 5r barrel, Med. Palma contour, 1 in 8", with 2" brake of Nathans design
Jewell trigger
Redding dies
Manners T-5A stock, studs front and rear, Flush cups left side
Stock painted CeraKote in GAP camo, metalwork is CeraKote Sniper Green, with grey contrasts. Gun has less than 300 rounds through it. Shoots well, I don't honestly know exactly how well, as no serious load development was done, just adjusted seating of 105 amax until gun went sub-MOA, then killed woodchucks. Gun can be seen on Nathans website under the varmint rifles page, or PM for pictures. Stock has a couple scratches in paint, barrel has tiny wearing of CeraKote at top of muzzle brake, from rubbing wall.
$3250 for gun without scope and rings
$4750 for Gun with Swarovski 5-25 BT, 4W reticle, and Leupold Mark IV steel rings
PM with any questions or for pictures
