Hubert- good question. Let me see if I can explain my concerns. Phil99 - good input, as always.
The old Buehler system on my rifle is actually quite nice - strong, precise and sleek. But the rings with this system are split only at the bottom, which I assume means that they (or at least the rear ring) must be slid over the scope tube lengthwise. To do that, the scope's ocular (rear) lens must unscrewed and removed. And I believe that's a bad idea with today's scopes which utilize internally-contained gas to keep the scope fog free (?).
I admit that I could be wrong in all of those assumptions.
Does anyone remember exactly how these old Buehler rings, which are split only at the bottom (the front ring has a retaining screw, the back ring does not), were suppose to be mounted to a scope? Here�s a photo of the FRONT Buehler ring with its retaining screw:
Here�s the REAR Buehler ring (no screw):
And here�s the Buehler base attached to the rifle:
Can or should this old Buehler system be used with a modern scope with a 36mm objective lens? If so, how does one get the rings on the scope? I've mounted many modern scopes on many modern rifles, but this one's got me temporarily stumped.