Handled a used one of these a few days ago and the only complaint I could see was I thought the bolt handle rode a little to close to the stock to get a good grasp on it. Are they all like this or is it just me?
They're all like that; in use, it's not so bad. What I did was to fill in the hollow part of the bolt knob as when it came from the factory, the hollow had a beveled edge that wore on my hand as I worked the bolt. Epoxy took care of that. I do wish CZ would sweep the bolt handle back and push it out from the stock about 1/8" like on the standard CZ 550's.
