I had that trigger assembly smeared blacker than a witches heart last night, but did not see a mark where it could be binding to the stock.
I also took more wood out of the channel that I cut for the bolt handle, to make sure it always closes properly.
Still no dice.
I know this is caused by pressure being applied somewhere when the action screw is tightened, I am getting the rifled bedded this week but before sending it off I am going to add a couple of small washers to the action screw as a temporary shim, to see if that allows me to tighten the screw up but maybe relieve some pressure on the sear/trigger.
I am also thinking I should replace the trigger with something better than that awful 1940's trigger.
What trigger would you suggest I go with?
Never done a trigger job myself any gotchas?
Thanks Gents