Wab-I put the press (Rockchucker)on my right, do all my case prep & priming/recharging right to left on left side of the press, Put scale checked powder measure in press (now put the scale away in its safe place), charge cases right to left into loading block, check powder level w/flashlight. Put seating die in press, place bullets in butter dish cover (much easier than out of the box) on right hand side of press, pickup up case in left hand place in shell holder, put bullet at case mouth and hold w/left fingers and operate press handle w/right hand to seat. Note, I only use one ctg. block and it it for charged cases ONLY! Empty/primed are in butter sized dishes, any vertical case at any time is charged. Seems like a safe way to avoid double charges to me. I only need about 3 feet total bench space 18" deep for all of this and 2/3 is on the left side of the press in front of me. I have never used a powder measure stand as they always appear to be in the way. I did see a photo of Mule Deer's bench where he had the measure mounted on a shelf above and in back of the loading area and it looked usable though and can be used to recharge directly into cases in the block, but I don't as above. If I have more than a loading block to do I just put the measure in the bench vice located at the extreme right end of the bench, seat bullets and repeat. -Muddy
