I have a 722 in 257 improved and was thinking of putting it in a 700 sa adl stock. I am just wondering if there is any problem with putting it in an ADL stock. Or will it only go in a BDL stock?
It is not difficult but several things must be done.
1) the safety lever either needs to be replaced to a 700 safety lever which requires a small notch be filed in the action rear tang. Or you can keep the 722 safety lever and make room for it alongside the tang (remove some of the stock).
2) You will need an ADL triggerguard.
3) Your magazine box is going to be too deep so you may need to cut it down or replace with a 700 box.
4) Watch the length of the action screws, especially the front as it will bind the bolt if it is too long (almost always).
