From Berger:

Q: If I use Moly Coated bullets how should I clean my barrel?
A: The following is one way to clean when using Moly Coated bullets. It is not likely the only way you can clean if you are using Moly Coated bullets.

1. Push one patch wet with Kroil Oil through the barrel
2. Repeat step 1.
3. Push one dry patch through the barrel.
4. Repeat step 3.
5. Push one patch wet with Butch's Bore Shine through the barrel.
6. Repeat step 5.
7. Let the barrel soak for 5 to 10 minutes.
8. Push one dry patch through the barrel.
9. Repeat step 8.
10. Using short strokes back and forth push one patch wet with USP or JB Bore Paste through the barrel.
11. Push one patch wet with Kroil through the barrel.
12. Repeat step 11 twice.
13. Push one dry patch through the barrel.
14. Repeat step 13 three times.
15. Use bore scope or visually inspect muzzle for copper fouling.
16. If copper is present repeat steps 10 through 15.
17. If you are storing the rifle push one patch wet with quality gun oil through the barrel.
back to top


Q: How do I break in a barrel using Moly Coated bullets?
A: Moly Coated bullets will not shoot consistently until a barrel is properly broken in with Moly Coated bullets. Walt Berger has found the following procedure to work best in his barrels.

For a new barrel:
1. Shoot one Moly Coated bullet then clean using the Moly Coated cleaning procedure listed above.
2. Repeat step 1 five times.
3. Shoot three Moly Coated bullets then clean using the Moly Coated cleaning procedure listed above.
4. Repeat step 3 five times.

For a broken in barrel:
1. Thoroughly clean the barrel.
2. Shoot ten Moly Coated bullets then clean using the Moly Coated cleaning procedure listed above.

Your barrel is now ready to shoot Moly Coated bullets.