85pc 7.5x54 French primed brass formed from 284 Winchester. I picked up a few hundred of these at a show and this is what I have left that I have not used.
Case lengths vary so some of the necks are on the short side if using light bullets. Some lube dents, have varying degrees of annealing at the shoulder, OD near base has been reduced.
I don't know what the primer is but I have loaded 200+ without a misfire. My first loads were with assorted pulled long bullets seated into the lands to fire-form and had good results. 3+ additional loads before some (5%�) of the necks and shoulders developed small cracks.
Purchased a bunch of new 7.5x54 brass and ammo so no need for these.
Hi, I can use your brass, PM to you following, thank you! I will PIF with 9MM brass, picked up from range, not prepped.....
