Home Forums Hunting & Shooting Hunting Rifles Kimber Roulette(finally got burned........)

FWIW, I just got back in from another test.

Shot a 10 shot group at 395 yards. Still breezy(5-15mph) but not too bad.


I checked the target after each shot and knew the bullet that landed at 6 o'clock was a pulled flyer so really other than that poor shot the group wasn't too bad considering. Roughly 6-7" inches across but at least the vertical spread was decent.
Not holding for wind, aimed at the dot for each shot.

I'd go hunting with this load and not worry one bit(58 grs H4831sc and 150 Partition). Virgin(un-sized) brass as well and I expect neck sized(fired) brass will help with accuracy.






Does anyone know what material they use for the current production Montana trigger guard?

I read they use aluminum for the Ascent so I am assuming the same is used for the Montana?