Bought this for my Rim-X , figured might as well know whether it was GTG before wasting a bunch of time. First couple times out I simply sighted it and shot groups.
First things first, I laid out the TTT at 9” intervals based on shooting 5 mil come ups at 50Yds. After noticing the discrepancy in elevation was going up equally after 5,10,15 and 20 I grabbed my LRF and verified my 50yd bench (after a lot of years shooting here) is actually 54 yards, so you’ll see in blue I adjusted my original 9” lines to 9 11/16” spacing (3.6” divided by 100yds, x 54yds = 1 15/16”/mil x 5 mils = 9 11/16”)
Shot zero, then used turrets to make 5 mil adjustments up to 20 mils, dropped it back to zero, used the reticle to shoot 5 and 10 (all the reticle has) then dialed 10 and shot 5 and 10 on the reticle again.
Off to the left of the 10mil line you’ll see where I was checking RTZ
Shot zero, dialed up 10, down 20 then back to zero 4 times, fifth time I dialed up the max it would go then back to zero. RTZ was excellent.
There was a 5-10mph left right wind blowing, 22deg out and snow on the ground.
The professional Benchrest setup
The target down range
The target after shooting
The target after making adjustments for the extra 4 yards I was actually shooting. (Tape over some addition holes, shot a few other rifles and taped those targets over this one.