Remington XP100 handgun. Built by Bullberry.

Chambered in 7mm IHMSA. Low round count
McMillan center grip stock
Nice light , crisp trigger
Mini M16 extractor
Finished in black cerakote
I just had the stock refinished in Cerakote. Black W/webbing
Muzzile brake
The scope base has also been cerakoted
Skeletonized bolt handle.
Front sling swivel stud


It has been very accurate with 162 ELD-M’s and 140gr Accubond’s @ 2420 FPS.

Includes RCBS FL die seat with seater. Also included is a Redding neck die.

30 or so formed cases (.300 Savage R-P)

$1375.00 Shipped. Apple Pay, Postal MO or check. Ships when check clears.

Will considering trading for Nightforce or Leupold scopes. Must have turrets and a MOA reticle.

More photo’s

Couple more.

Very nice piece.....as you know. I have three.

Is this a tight neck chamber? And how many rounds fired. Thanks

I [bleep] a 40x40 with a pistol just about identical to that back in 1985.

Less than 200. I haven’t checked the chamber. I have only shot the 30 or so cases I got with it a couple times. It was a spontaneous purchase . This is what it looked like before I had Orgun Gunsmithing refinish the stock and metal. Add a sling swivel stud and muzzle brake. I planed on hunting with it but haven’t got around to using it.

The case neck wall thickness on the brass I got with it is .011 . They have been turned.

The Cerakote, stud and stock refinishing ran me $475.00 .

These are the dies that come with it.

This handgun was shot in the nationals in Texas with a different barrel back around 85.

I have only shot it off the bench a couple times.

Well, darn it all anyway - an XP100 in a center grip stock has been on my bucket list for a long time but I haven't found just the right one. Been drooling over this one since you posted it and it sounds like I should be able to neck up Lapua 22-250 brass (which seems to be readily available) to make 7mm IHMSA. I can no longer resist, so let's send it to Montana - PM incoming...