Home
Posted By: RatherBHuntin What ring n mounts for a tikka t-3 - 09/18/14
I just purchased a new in box tikka 260. My question is...will the factory rings hold without slipping or should I get something else? If so, what would you recommend? I don't need a hundred dollar set of mounts, but do want something solid and secure that won't slip around. What say you?
Posted By: bsa1917hunter Re: What ring n mounts for a tikka t-3 - 09/18/14
Look into 16bore's milled talleys. They look like just the ticket. If I owned a Tikka, that's the route I'd take if the factory rings weren't adequate.
Posted By: Mackay_Sagebrush Re: What ring n mounts for a tikka t-3 - 09/18/14
[Linked Image]

Talley lightweight rings.
Posted By: mailmanmark Re: What ring n mounts for a tikka t-3 - 09/19/14
weaver bases with Warne rings here....
Posted By: RatherBHuntin Re: What ring n mounts for a tikka t-3 - 09/19/14
I think I am gonna go with the milled Tallies from "16bore".
Posted By: backcountryal Re: What ring n mounts for a tikka t-3 - 09/19/14
Absolutely nothing wrong with the Tikka rings, will hold your scope without moving for years.
Posted By: 4th_point Re: What ring n mounts for a tikka t-3 - 09/19/14
I had the factory Tikkler mounts move. Correction, the little recoil lug (pin) migrated through the alloy ring (i.e. the harder pin pushed its way through the soft alloy and started to bulge it). This was on a 300 WSM, but I had five Tikklers and didn't use the factory rings again.

I like the DNZ ringmount myself, Low.
© 24hourcampfire