DO you have loading data for 3"& 3 1/2"

I have been looking for loading data for 3 and 3 1/2 intch 12ga. hulls. I'm wundering if buying a convertion for a reloader would be worth it. , thanks

I don't have any experience loading 3 or 3 1/2 inch shells; but, looking at my 2 3/4 inch press I don't believe it could be converted to load longer shell. A 3 inch press could be easily converted to load 2 3/4 inch shells IMO. Load data books are usually stocked or are available from the dealer who stocks reloading supplies.An avid waterfowler, I just never got into the 3 or 3 1/2 inch craze. Steel shot and lead shot will never perform the same. I am just more selective with my shots and my freezer has never gone wanting for anything.Hope this helps.Wall

I need Guns:Check out <A HREF="http://www.ballisticproducts.com." TARGET=_blank>www.ballisticproducts.com.</A> It is pretty much the holy grail for long range, waterfowl type shotgunning loads. I haven't personally reloaded any 3 1/2 inchers since I have been able to buy some decent steel shells in that grade on closeout a couple of times, and have not felt the need.Wall:You are right about steel and lead, and you are also right that steel kills them dead, it is not worse at closer ranges, just different and probably a little tougher to shoot as well, due to less pattern stringing and denser shot clusters. But it will cripple badly if you don't center the bird. I always carry a handful of the cheap, smallest steel shot size I can find for cripples. Head shots are about the only way with steel with a duck on the water. Since, worse luck, I am dogless at this time, if his head comes up, I shoot him again, right then.Check out the site above, they have a new product out, called hevi-shot, should be absolutely wonderful for long range shooting. Heavier than lead, with less deformation, reports extremely good pattern density at much longer ranges. I haven't tried any yet, but certainly will this fall in Canada when duck season rolls around. Only 4 months now, Ha.

Well thanks for that link

IMHO RSI is much better for high speed steel loads.
 If you want to reload 3.5 you need a Steelmaster(at least in MEC). I bought a Steelmaster but found that if you load your own the only advantage 3.5 has over 3 is shot weight. If your gun patterns well you don't need 1 9/16 oz of shot.
 
 http://www.alliantpowder.com/
 
 http://www.reloadingspecialties.com/