I have three of these makitas. I want to hang them on hooks.
Have you done this?
How have you attached the loops/Ds? Short screws? Epoxy?
Thanks.
I keep mine hanging on a piece of horizontal 2 inch angle with the L up tacked to the end of the welding table. The wheel hooks over the turned up edge of the angle.
I also hang mine on a piece of angle. You could use rod or bar too.
Thanks guys. That’ll work. 👍
If taken 1/4” cold roll. Bent into a V to catch the guard. Make it standoff whatever the thickness of the guard is away from where you mount it.
I like the V design as well.
Oh yeah.
Old work habits.
Blow up a cutting wheel and it’ll make you a believer.
I have the guard on the cutting wheel, but removed them from grinding wheel and wire cup.
i stick the side handle on the 1/2 in pipe that the ext. cord is rapped around